Top sellers

Viewed products

Manufacturers

Zenoah Titan ZG 62PCI-HV with Rubber Spark Plug Cap Microprocessor-Ignition

ZG6594

New product

Backorder (5 - 6 working days)

394,31 €

Add to wishlist

Data sheet

Suitable for Airplanes
Fuel Type Gas

More info

Titan ZG 62PCI-HV

In 1990 Komatsu reworked the cylinder specially for model aircraft purposes this S cylinder had the transfer passages altered as well as the combustion chamber. This resulted in an increase of 200 rpm in the 6,500 range. Fit a tuned pipe and the rpm is considerably increased, giving a power of 6,6 hp at 8,400 rpm.

The crankshaft is a hefty piece of forged steel, induction hardened, with a diameter of 15 mm and supported in two large ballraces, the conrod is a forged unit also induction hardened with caged roller bearings both ends, the gudgeon pin is hollow. There are two thin pegged rings. The ignition unit consists of two separate coils, both fixed to the side of the motor causing no interference with the cooling air. The standard Walbro pump carburettor is fitted with a choke.

The very wide and cleanly formed cooling fins allow the use of large propellers causing the motor to turn at relatively low speeds. For aerobatic aircraft like our CAP 21 the 22x10" or the 22x12" Menz S propeller has proved to be very good. Our big Tiger flies best with the 24x10". If you wish to, or must, reduce the noise still further, then you can pull the intake air out of the fuselage by fitting a 90 degree bend between the carburettor and motor. The intake noise is louder than the noise from the standard silencer. This bend by lengthening the intake tract allows the fitting of a 24x12" or 26x10" Menz S propeller, of course you are not going to get the maximum power from the motor by this method, but you have more than enough power to fly our big Tiger with the 62?s throttle set at just a rather fast tickover.

The lowest possible noise level in flight with lots of power is obtained with our Hydro-Mount-System, coupled with the Stainless steel silencer, sucking the intake air out of the fuselage and fitting a Super Silence 21x12" Carbon 3-blade propeller at 6,300 rpm. For higest performance use the Super Silence 24x10" Carbon 2-blade prop. It produces 130 N static thrust at 6500 rpm.

The ZG 62PCI-HV is delivered complete with silencer, fitted with 40 mm prop hub, but
without motormount.


Specifications:

  • Capacity: 62 cc
  • Bore: 47,5 mm
  • Stroke: 35 mm
  • Power: 4,3 hp
  • with tuned pipe: 6,6 hp
  • Weight: 1880 g without silencer and engine mount

Product weight: 2,80 Kg

Five-year warranty motor

Workshop

REPAIRS - MAINTENANCE - UPGRADES



We guarantee repairs to your radio equipment, from Drones, Cars, Helis, Planes or Boats, with its own workshop and specialized personnel. (static, radio control, electronic repair, etc.)

You can count on a service of excellence, with advice of accessories or parts adjusted to your needs and with the guarantee of the quality that our services offer.

We know that not everyone is experienced and often the first steps in radiomodelismo are obscure and difficult, but we are here to help and follow you in the evolution of your knowledge of this fabulous hobby.

Want to evolve your vehicle? Well, you can count on the best advice to do a complete upgrade, in phases or even to add the accessory that you want but do not have enough knowledge to apply it.

Count on us, count on free budgets, clear and without surprises in the end.

Purchased at SVModelismo or another shop, your vehicle is always well treated with our technicians and with a complete workshop.

Click here and bookmark a visit or ask for a free quote!

30 other products in the same category: