Lights on for the big crossing! Easy-Light is more than just a light module. With the Easy-Light switching module, functions can be assigned to up to 5 different channels. The connection of the function to be controlled and the connection to the receiver takes place directly on the control board and is soldered on there. The module is then plugged into a free receiver slot and can be addressed via the remote control. The 5 channels can be switched in parallel. The dimensions of 16 × 12 mm are suitable for a variety of models. The light package contains the Easy-Light control module and connection cable for the receiver (not soldered on). The switching module switches "minus" through, the respective consumer is supplied with "plus" on the other side. The connection can be made from the "Plus" connection on the circuit board, but can also be taken directly from the drive battery. This can also be used, for example, to operate consumers that require a voltage of 7.2V. The operation of mixed loads (eg position light 4.8V and searchlight 7.2V) is therefore not a problem. When using LEDs, the corresponding series resistors must be taken into account. All 5 channels can each be loaded with 500 mA and switched collectively.