Semi-scale SWIFT with optimized wings for a more general-purpose flight

Our SWIFT 3,14m (#02074) is an aerobatic beast, exclusive machine, only dedicated to this category and for the pilots seeking very neat trajectories.

By creating this new SWIFT (#02099) with lengthened wings equipped with camber flaps, the sailplane is transfigured and becomes much more general-purpose. By coupling the flaps with the ailerons, the roll performances are always quite present. But especially, these same flaps added to the larger wing surface and higher wing aspect ratio allow this model to become a soaring machine with unquestionable qualities.

• Fuselage molded in fiberglass with reinforcements, white gelcoat finish. Rudder installed. Wing joiner tube and incidence pins in place, airframe geometry performed on jig at the factory. Elevator servo tray in place. Ruuder control installed and connected to rudder control horn.
• PVC canopy to be cut and glued to its fiberglass frame.
• Wings: foam core abachi sheeted and covered with Oracover®, reinforced with numerous fiberglass ties on the top and on the bottom under the wing skin. Speedbrakes installed. Ailerons and Flaps pin hinged, finished. Wing servo wells prepared.
• Wing joiner: carbon rod diameter 16mm.
• Removable horizontal empennage: foam core abachi sheeted and covered with Oracover®, finished.
• Rudder molded in fiberglass, red gelcoat finish
• First quality accessories.
• Assembly plan.